Ducati TT1, Ducati TT2 and Ducati 750 F1 Forum
http://ducatittandf1.com/

TT2 Tribute Build
http://ducatittandf1.com/viewtopic.php?f=27&t=11513
Page 2 of 2

Author:  jr91 [ Fri Mar 10, 2017 5:17 pm ]
Post subject:  Re: TT2 Tribute Build

Hi Mike,

The valves were cleaned up using a wire brush in drill press before starting all the measuring process. I measured the valve to piston clearance firstly using the same solder wire (1.6mm). There were no indents on the wire which means I at least 1.6mm gap. I then measured using a blob of bluetac and found the exhaust at around 3.5mm and the inlet >4mm. I'm not sure how strictly accurate the bluetac technique is but even if the error is significant, there seems to be plenty of room.

No machining required...happy days!!

Author:  jr91 [ Sun Mar 12, 2017 5:17 pm ]
Post subject:  Re: TT2 Tribute Build

Attachment:
IMG_0458.JPG
IMG_0458.JPG [ 451.66 KiB | Viewed 5624 times ]


The motor is finally buttoned up and ready to go! Very exciting!

Author:  618F1 [ Sun Mar 12, 2017 8:11 pm ]
Post subject:  Re: TT2 Tribute Build

You were squirreling away some nice parts for this one, weren't you? If the inside is like the outside, and the rest of the bike like this it should run like a champ. MikeV

Author:  jr91 [ Wed Mar 15, 2017 12:02 am ]
Post subject:  Re: TT2 Tribute Build

It's been a stressful time over the last couple of years while I've been accumulating parts. I break into a cold sweat every time my wife goes anywhere near my credit card statements. I have to carefully and discreetly file them away somewhere before they can be screened. Talk about living on the edge...

More engine porn

Attachment:
IMG_9050.JPG
IMG_9050.JPG [ 1.19 MiB | Viewed 5585 times ]

Attachment:
IMG_9045.JPG
IMG_9045.JPG [ 1.98 MiB | Viewed 5585 times ]

Attachment:
IMG_9057.JPG
IMG_9057.JPG [ 2.02 MiB | Viewed 5585 times ]

Page 2 of 2 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/