Ducati TT1, Ducati TT2 and Ducati 750 F1 Forum
http://ducatittandf1.com/

Cranckshaft bearing
http://ducatittandf1.com/viewtopic.php?f=25&t=11613
Page 3 of 3

Author:  583 [ Sun Aug 13, 2017 4:56 pm ]
Post subject:  Re: Cranckshaft bearing

Hi Ducadini thanks for replying.
This discussion is open,i was just wondering if there is an alternative to the stock crankshaft bearing, this is why i named 6307/6207, but if i understand these bearings did not comply with the stock specs.
Ciao
Filippo

Author:  wdietz186 [ Wed Aug 16, 2017 9:53 pm ]
Post subject:  Re: Cranckshaft bearing

Filippo, Loctite make a compound specific for mounting bearings. I think it is green in color and called Stud and Bearing mount. In a pinch I've used the high strength Red 271 [I think] with decent results when the fit in the case wasn't too loose. Yes those pics do show angular contact type bearings.

Author:  Cal [ Sat Aug 19, 2017 5:03 pm ]
Post subject:  Re: Cranckshaft bearing

I have one nos main bearing and main seal in my stash of xtra parts. But need someone to confirm this is good spec for you to use. PICTURES ATTACHED. Made in usa bearing, New Departure #Q20307DTL (I think 15 deg angular contact?)
Seal is Corteco 75-95-12. If you can use $30?

Clay

Attachments:
20170819_135204.jpg
20170819_135204.jpg [ 750.52 KiB | Viewed 1447 times ]
20170819_134717.jpg
20170819_134717.jpg [ 865.34 KiB | Viewed 1447 times ]

Author:  583 [ Tue Aug 22, 2017 9:02 am ]
Post subject:  Re: Cranckshaft bearing

Hi Wdietz186 and thanks for Info about Loctite.

Hi Cal , the bearing shown in your photo look wery close to the ones i dismounted.
75-95-12 could this code be referred to inch instead centimetres?
Ciao
Filippo

Author:  Cal [ Tue Aug 22, 2017 12:55 pm ]
Post subject:  Re: Cranckshaft bearing

583 wrote:
Hi Wdietz186 and thanks for Info about Loctite.

Hi Cal , the bearing shown in your photo look wery close to the ones i dismounted.
75-95-12 could this code be referred to inch instead centimetres?
Ciao
Filippo


Hi,
The dashed #'s are for the seal. I think that must be used on a dry clutch pantah, I bet your 350 is not dry?

Author:  583 [ Sun Sep 24, 2017 1:53 am ]
Post subject:  Re: Cranckshaft bearing

Hi everybody
So, after a same searches I went to my local Ducati store and ask for crankshaft bearings.
For Pantah and Alazzurra engines, Ducati supply the same bearings used in 90'/00' models.
There is difference between the new one and the old ones, but at the end I buy these , on the following link you find the new ones and the old ones.
https://www.flickr.com/photos/156916018 ... res/6hGEvx

Ciao
Filippo

Page 3 of 3 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/