Ducati TT1, Ducati TT2 and Ducati 750 F1 Forum http://ducatittandf1.com/ |
|
Clutch Confusion http://ducatittandf1.com/viewtopic.php?f=24&t=11723 |
Page 1 of 1 |
Author: | TheClaw [ Sun Jan 21, 2018 5:50 pm ] |
Post subject: | Re: Clutch Confusion |
This is going on a track bike, is it reasonable to safetywire the bolts holding the control disk or is that over kill? |
Author: | 618F1 [ Sun Jan 21, 2018 6:14 pm ] |
Post subject: | Re: Clutch Confusion |
It almost looks like a wet clutch set installed in a dry clutch. But the drawing looks wrong for any Pantah. The last plate (driving, or whatever it is) installed, facing you, must have a metal outer surface, have the outside tabs, and be big enough to be held in by the big ring. Then should have about 1/8th inch of space below the retaining ring, before the pressure plate is installed. Looking again, why dont you put that small driven ring inside the stack, just after the conical ring is installed, and then put that metal surface friction (driving) ring outside? Problem solved? No need for wire. |
Author: | TheClaw [ Tue Jan 23, 2018 10:18 pm ] | ||
Post subject: | Re: Clutch Confusion | ||
From the parts diagram it looks like a metal disk goes in first then the disks with the tabs, alternating until you get to the outside disk with the tabs. Except that in the diagram, the outside disk is a different part number. Looks backwards from what I took out. No guarantee that what I took out was correct though.
|
Author: | pantah_good [ Tue Jan 23, 2018 11:25 pm ] | ||
Post subject: | Re: Clutch Confusion | ||
May help if you don't already have it. From the F1 service manual available on the Bevel Heaven website. Old rule of thumb...When in doubt, safety wire anything you don't want falling off.
|
Author: | TheClaw [ Wed Jan 24, 2018 8:54 am ] |
Post subject: | Re: Clutch Confusion |
pantah_good wrote: May help if you don't already have it. From the F1 service manual available on the Bevel Heaven website. Old rule of thumb...When in doubt, safety wire anything you don't want falling off. I have the manual but it doesn't get into the specifics of the order of the disks and the Surflex clutch pack is different that what I took out of there. Thinking I just match what I took out and keep my fingers crossed. I like your rule of thumb. |
Author: | 618F1 [ Wed Jan 24, 2018 11:52 am ] |
Post subject: | Re: Clutch Confusion |
The order in the parts manual will work. But don’t use it for the cam bearings. MikeV |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |