Ducati TT1, Ducati TT2 and Ducati 750 F1 Forum
http://ducatittandf1.com/

wanted brembo rebuild kit
http://ducatittandf1.com/viewtopic.php?f=22&t=11736
Page 1 of 1

Author:  ducttf1 [ Sat Feb 10, 2018 7:05 pm ]
Post subject:  wanted brembo rebuild kit

Hi everyone, you did so well with the tank strap, now I am looking for a rebuild kit for a 17mm brake goldmine master. Part # 110.4052.10 any help would be greatly appreciated. I tried the typical places but have not been able to find one. Any help will be greatly appreciated! Lou

Author:  pantah_good [ Sat Feb 10, 2018 8:29 pm ]
Post subject:  Re: wanted brembo rebuild kit

17mm brake master - which one is that? Is that p/n for the kit or the master?

Author:  618F1 [ Sat Feb 10, 2018 9:27 pm ]
Post subject:  Re: wanted brembo rebuild kit

Hay Lou. Have you measured that piston? Is it any different than the 15.85mm I get for the one used in the 15mm master, and occassional one marked 16mm? The new repair kits for 15mm fit both. I sometimes think Brembo was loosey-goosey with the markings. Maybe the 17 was to make riders feel better, and just brake later. MikeV

Q: when you wrote “goldmine” did that mean expensive?

Author:  ducttf1 [ Sat Feb 10, 2018 10:19 pm ]
Post subject:  Re: wanted brembo rebuild kit

The 'goldline' master part number is 10.3670.13. The spellcheck on the Forum makes it goldmine. The other number is the rebuild kit. No Mike, that piston is 17mm and the Brembo book shows it as that. Lou

Author:  pantah_good [ Sun Feb 11, 2018 12:38 am ]
Post subject:  Re: wanted brembo rebuild kit

What is/was that master used on?

Author:  750TT [ Sun Feb 11, 2018 8:28 am ]
Post subject:  Re: wanted brembo rebuild kit

Hi Lou. You asked Ian Gowanloch??, I bought a set a few years ago.

Author:  pantah_good [ Sun Feb 11, 2018 11:53 am ]
Post subject:  Re: wanted brembo rebuild kit

Found the master, figured it would be something obscure. Nice one Lou! You've checked TAW right?

http://www.cyclebrakes.com/html/brembo_cylinders_1.html

https://www.tawperformance.com/17m-lrd-mccy-kit

Author:  flattop900 [ Sun Feb 11, 2018 2:15 pm ]
Post subject:  Re: wanted brembo rebuild kit

The rear 17mm Goldmine master is listed as having the same part number for the piston /seal.

Attachments:
PS17 gl.gif
PS17 gl.gif [ 19.75 KiB | Viewed 1457 times ]

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/