Here is a set of Dymags with the Ducati rotor bolt pattern (80/101mm) and front wheel hub width of 88mm. Rear has same rotor pattern, but the width at the sprocket hub side suggests that an offset front sprocket is needed. These wheels are "tired": The front has been professionally repaired (welded and checked for straightness), and I was told it was "good to go; the rear needs a ton of cleaning and restoration. NO GUARANTEES on either. There is no cush; these were contained in the sprockets at the time, and that was covered in out site a short while back. I think a simple Menani-like sprocket setup could be made.
18x2.5 front and 18x4.0 rear. Both wheels for $400 plus shipping
Attachment:
df1.JPG [ 3.8 MiB | Viewed 3116 times ]
Attachment:
df3.JPG [ 3.87 MiB | Viewed 3116 times ]
Attachment:
df4.JPG [ 4.04 MiB | Viewed 3116 times ]
Attachment:
df6.JPG [ 3.88 MiB | Viewed 3116 times ]
Attachment:
dr1.JPG [ 3.96 MiB | Viewed 3116 times ]
Attachment:
dr2.JPG [ 3.78 MiB | Viewed 3116 times ]
Attachment:
dr3.JPG [ 4.13 MiB | Viewed 3116 times ]
Attachment:
dr6.JPG [ 3.76 MiB | Viewed 3116 times ]