DUCATI TT and F1 FORUM
 
It is currently Tue Feb 20, 2018 9:24 pm

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: More wheels
PostPosted: Sun Jan 14, 2018 7:05 pm 
Offline

Joined: Thu Oct 14, 2010 11:23 am
Posts: 1180
Here is a set of Dymags with the Ducati rotor bolt pattern (80/101mm) and front wheel hub width of 88mm. Rear has same rotor pattern, but the width at the sprocket hub side suggests that an offset front sprocket is needed. These wheels are "tired": The front has been professionally repaired (welded and checked for straightness), and I was told it was "good to go; the rear needs a ton of cleaning and restoration. NO GUARANTEES on either. There is no cush; these were contained in the sprockets at the time, and that was covered in out site a short while back. I think a simple Menani-like sprocket setup could be made.

18x2.5 front and 18x4.0 rear. Both wheels for $400 plus shipping
Attachment:
df1.JPG
df1.JPG [ 3.8 MiB | Viewed 145 times ]

Attachment:
df3.JPG
df3.JPG [ 3.87 MiB | Viewed 145 times ]

Attachment:
df4.JPG
df4.JPG [ 4.04 MiB | Viewed 145 times ]

Attachment:
df6.JPG
df6.JPG [ 3.88 MiB | Viewed 145 times ]

Attachment:
dr1.JPG
dr1.JPG [ 3.96 MiB | Viewed 145 times ]

Attachment:
dr2.JPG
dr2.JPG [ 3.78 MiB | Viewed 145 times ]

Attachment:
dr3.JPG
dr3.JPG [ 4.13 MiB | Viewed 145 times ]

Attachment:
dr6.JPG
dr6.JPG [ 3.76 MiB | Viewed 145 times ]


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
Template made by DEVPPL