Ducati TT1, Ducati TT2 and Ducati 750 F1 Forum
http://ducatittandf1.com/

More wheels
http://ducatittandf1.com/viewtopic.php?f=22&t=11718
Page 1 of 1

Author:  618F1 [ Sun Jan 14, 2018 7:05 pm ]
Post subject:  More wheels

Here is a set of Dymags with the Ducati rotor bolt pattern (80/101mm) and front wheel hub width of 88mm. Rear has same rotor pattern, but the width at the sprocket hub side suggests that an offset front sprocket is needed. These wheels are "tired": The front has been professionally repaired (welded and checked for straightness), and I was told it was "good to go; the rear needs a ton of cleaning and restoration. NO GUARANTEES on either. There is no cush; these were contained in the sprockets at the time, and that was covered in out site a short while back. I think a simple Menani-like sprocket setup could be made.

18x2.5 front and 18x4.0 rear. Both wheels for $400 plus shipping
Attachment:
df1.JPG
df1.JPG [ 3.8 MiB | Viewed 1827 times ]

Attachment:
df3.JPG
df3.JPG [ 3.87 MiB | Viewed 1827 times ]

Attachment:
df4.JPG
df4.JPG [ 4.04 MiB | Viewed 1827 times ]

Attachment:
df6.JPG
df6.JPG [ 3.88 MiB | Viewed 1827 times ]

Attachment:
dr1.JPG
dr1.JPG [ 3.96 MiB | Viewed 1827 times ]

Attachment:
dr2.JPG
dr2.JPG [ 3.78 MiB | Viewed 1827 times ]

Attachment:
dr3.JPG
dr3.JPG [ 4.13 MiB | Viewed 1827 times ]

Attachment:
dr6.JPG
dr6.JPG [ 3.76 MiB | Viewed 1827 times ]

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/