Ducati TT1, Ducati TT2 and Ducati 750 F1 Forum
http://ducatittandf1.com/

Oil pump gear
http://ducatittandf1.com/viewtopic.php?f=10&t=11721
Page 1 of 1

Author:  boucher [ Fri Jan 19, 2018 3:57 am ]
Post subject:  Oil pump gear

Hi Ducati knowledge people, does a Ducati f1 dry clutch share a different oil pump gear? The pantah pump gear is 44T The primary drive is 22T. The f1 is 30T on primary drive. What do I need for the oil pump gear (no of teeth/model) Thanks Boucher.

Author:  flattop900 [ Fri Jan 19, 2018 9:31 am ]
Post subject:  Re: Oil pump gear

Good morning Mr.Boucher...
I asked the same question earlier this year. The number MikeV posted was 58. Search "oil pump" and you will see other combinations that Mike posted. I found it easier and just as economical to purchase the entire pump assembly.
Regards...
Flattop

Author:  ducttf1 [ Fri Jan 19, 2018 11:56 am ]
Post subject:  Re: Oil pump gear

Also note that the early pantah oil pump housings will not clear the later straight cut gears that are a larger diameter. You will see that all the later pump housings have a crescent shaped notch machined on the top of the them to clear the gear. Lou

Author:  618F1 [ Fri Jan 19, 2018 12:40 pm ]
Post subject:  Re: Oil pump gear

Look for the March 22, 2017 postings in tt2 technical section Boucher, started by flattop.

MikeV

Author:  618F1 [ Fri Jan 19, 2018 12:40 pm ]
Post subject:  Re: Oil pump gear

Look for the March 22, 2017 postings in tt2 technical section Boucher, started by flattop.

MikeV

Author:  flattop900 [ Fri Jan 19, 2018 12:54 pm ]
Post subject:  Re: Oil pump gear

That's something else I never noticed about the oil pumps.
First one early hand ground for clearance.
Second one machined.
Third one cast.
So with all these revisions going on, are the internal gears all going to be the same?
Regards...
Flattop

Attachments:
oil pumps.JPG
oil pumps.JPG [ 4.36 MiB | Viewed 1810 times ]

Author:  ducttf1 [ Fri Jan 19, 2018 3:06 pm ]
Post subject:  Re: Oil pump gear

As always, when in doubt ask Mike V! Lou

Author:  boucher [ Fri Jan 19, 2018 5:20 pm ]
Post subject:  Re: Oil pump gear

So I'm after a oil pump with a 58t to run against the 30t primary drive. Thanks Boucher.

Author:  618F1 [ Fri Jan 19, 2018 8:51 pm ]
Post subject:  Re: Oil pump gear

Maybe. Depends. MikeV

Author:  Palmer [ Mon Jan 22, 2018 11:00 am ]
Post subject:  Re: Oil pump gear

From experience, try and keep the primary and oil pump gears as an original set, swapping gears can sometimes generate a LOT of engine noise even thought the gear teeth look identical.

Palmer

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/