Ducati TT1, Ducati TT2 and Ducati 750 F1 Forum http://ducatittandf1.com/ |
|
Help. Parts Needs Pantah Heads http://ducatittandf1.com/viewtopic.php?f=10&t=11418 |
Page 1 of 1 |
Author: | Percy [ Fri Sep 02, 2016 9:10 am ] |
Post subject: | Help. Parts Needs Pantah Heads |
My TT1 has a Paso bottom end which is mated to Pantah heads ... The Pantah parts manual shows that the inlet manifolds are secured by Nyloc nut (51); capped washer (50); a steel sleeve (49) and a rubber washer/sleeve (48) Attached is a picture showing these parts. Whilst undertaking some work on the heads recently I found that the rubbers on the vertical head have disintegrated. These rubbers have a distinguished shoulder and would be very hard to replicate (certainly for me ...!) I have trawled the internet but am finding it difficult to locate replacements anywhere .... I would very grateful if somebody could direct me in the correct direction or suggest a suitable alternative .... Many thanks Tom Attachment: Attachment:
|
Author: | jc_ducati [ Sun Sep 04, 2016 9:21 pm ] |
Post subject: | Re: Help. Parts Needs Pantah Heads |
If you do find a source please let us know because I've had to re-use some second-hand rubbers that were slightly better than the old ones. Good luck because as I far as I can tell they are unique to Pantahs and Ducati and other sources (eg Ian Gowanloch) have long been out of stock of these. |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |