|
View unanswered posts | View active topics
|
Page 1 of 1
|
[ 4 posts ] |
|
Author |
Message |
boucher
|
Post subject: 38mm dellorto Posted: Fri Jan 30, 2015 5:20 am |
|
Joined: Wed Nov 17, 2010 5:45 am Posts: 391
|
Has any one had 38mm dellorto's fitted to a 750 pantah engine? Other than the size are they the same as a 40mm bodied dellorto?? Thanks Boucher.
|
|
Top |
|
|
pantah_good
|
Post subject: Re: 38mm dellorto Posted: Fri Jan 30, 2015 9:11 am |
|
Joined: Fri Oct 15, 2010 12:20 pm Posts: 1275 Location: Vermont, USA
|
Physically, yes, pretty much the same. I switched the 38's off my R90s for the 40's off my bevel for a while. Basically a remove and replace job - not counting the jetting/set up of course. Bill P.s. If you are considering a used set off a R90s, beware of high mileage ones. My R90s has about 120K miles on it, and I decided the bore for the slide was probably too badly worn to be able to tune them in properly. New body's are the only new part you can't buy for them.
|
|
Top |
|
|
618F1
|
Post subject: Re: 38mm dellorto Posted: Fri Jan 30, 2015 12:50 pm |
|
Joined: Thu Oct 14, 2010 11:23 am Posts: 1812
|
Yes, the 38s and up are PHMs. All things interchange or fit together. MikeV
|
|
Top |
|
|
boucher
|
Post subject: Re: 38mm dellorto Posted: Sat Jan 31, 2015 4:27 am |
|
Joined: Wed Nov 17, 2010 5:45 am Posts: 391
|
Thanks for info guy's. Boucher.
|
|
Top |
|
|
|
Page 1 of 1
|
[ 4 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 6 guests |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|
|